Products:
Battery Holders
Capacitors
Connectors
Gas tubes
Heat Sinks
ICs >> STM32 microcontrollers
LCD Module
LED Display
LED Lens
LED Lights
LED Module
Materials
Miniature Speakers
Plastic & Hardware
Potentiometers & Encoders
Resistors
Power Supplies
Power supply filters
Quartz Crystal
Switches
Test Probes
Thermistors
Varistors
|
|
Power Supplies / T Series /
T-60W-D series
 |
Normal triple switching power supply
Features:
- Universal AC input
- Small volume, low weight, high efficiency
- Protections:short circuit/over load/over voltage
- LED indicator for power on
- 100% full load burn-in test
- 2 year warranty |
|
Model |
T-60D |
|
output |
DC voltage |
CH1: +5V |
CH2: +12V |
CH3:+24V |
CH4:-12V |
|
Voltage tolerance |
±2% |
±6% |
±5% |
±5% |
|
Rated current |
8A |
3A |
1.5A |
1A |
|
Current range |
0.5~8A |
0.1~3A |
0.1~1.5A |
0~1A |
|
Rated power |
60W |
| Ripple&noise |
80mvp-p |
120mvp-p |
80mv |
120mvp-p |
|
DCvoltage ADJ.range |
CH1: -9%~+10% |
|
input |
Voltage range |
90~264VAC, 127~373VDC |
|
Frequency |
47~63HZ |
|
AC current |
1.8A/115VAC, 0.9A/230VAC |
|
Efficiency |
72% |
|
Inrush current |
Cold start current 25A/115VAC, 50A/230VAC |
|
Leakage current |
< 2mA/240VAC |
|
protection |
Overload |
Rated output power 110%~150 start over load protection |
|
protection type: hiccup mode, auto-recovery after fault condition is removed |
|
Over voltage |
CH1: 115%~135% |
|
protection type: hiccup mode, auto-recovery after fault condition is removed |
|
environment |
Working temp, humidity |
-10°C~+60, 20%~90%RH |
|
Storage temp, humidity |
-20°C~+85, 10%~95%RH non-condensing |
|
Withstand vibration |
10~500HZ, 2G 10min/1cycle, period for 60 minutes, each axes |
|
safety |
Withstand voltage |
I/P-O/P:1.5KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC |
|
Isolated resistance |
I/P-O/P,I/P-FG,O/P-FG:100M ohms/500VDC |
|
fit standard |
Safety standard |
Fit UL1012 |
|
EMC standard |
EN55022, CLASS A |
|
others |
Dimension |
159*97*38mm (L*W*H) |
|
Weight/packing |
0.5kg/45pcs/23.5kg/0.041m3/1.45CUFT |
|
note |
1. All parameters NOT specially mentioned are measured at 230VAC input,
rated load and 25°C of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using
a 12"
twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance: includes set up tolerance, line regulation and load regulation. |
|
